Error: There is not enough memory to run ScanDisk...(due to low memory).
Error:
There is not enough memory to run ScanDisk.
Cause:
Setup has encountered problems during the disk-checking phase due to insufficient conventional and/or upper memory.
Solution:
Exit Setup and run SETUP /IS to disable the 'ScanDisk' feature.
1) Exit Setup.
2) Run Setup by typing the following:
SETUP /IS
(This procedure will cause Setup to bypass the hard-disk check.)
NOTE: This method of Setup is not recommended because hard-disk problems remain undetected and may surface later when Windows 95 is running.
